We have the ability to produce most of the PCBs for our clients. If you have some complex PCB that needs special handing, or you are not sure if you have the ability to produce or not. Please contact us at [email protected] for an answer. Enclosed with your GERBER file or all other design drawing for our evaluation. More about the list of our capabilities, please refer to Capacity.
Yes, the submitted hole size is the final hole size within a tolerance of 1 mil.
14 mils to 150 mils – 1 mil increments
150 mils to 200 mils – 5 mil increments
above 200 mils – holes would be routed out
We only use drills in imperial units. Files submitted in metric units (mm) would be converted to imperial units (mils) and rounded up to the next mil.
When requesting an pcb online quote, the quote form can handle mm units as well as inches for dimensions.
All internal cutouts/slots/milling should be specified on the same layer is the board outline. The the minimum routable slot size is 32 mils. During order time, please state this requirement in the “Special Request” section so that our CAM engineers is aware of it. This is not something we encounter often – so there are chances we may overlook it. Make sure it’s known to us.
No. Only 1 design per setup is allowed.